Ducati Super Sport SS800 Owner's Manual page 35

2) Move the cold start lever to the B position (fig. 30).
3) Check that the stop switch (1) is positioned to
then press the starter button (2).
This model is equipped with a servoignition system.
To achieve assisted engine starting, press the button (2) and
release it immediately. Pressing the button (2) operates
automatic engine starting for a maximum period of time that
varies depending on engine temperature.
When the engine has started, the system prevents the
starter motor from turning over. If the engine fails to start,
allow at least 2 seconds before pressing the starter button (2)
again.
Let the engine start without using the throttle control.
4) Move the cold start lever to the vertical position (A) to
let engine idle at about 1400-1500 rpm.
Important
Do not rev up the engine when it is cold. Allow some
time for oil to reach all points that need lubricating.
5) As the engine warms up, move the cold start lever
gradually towards the vertical position (A). Once fully
warm, the engine should hold idling rpm with the cold
start shut down.
(RUN),
1
2
A
B
E
fig. 29
fig. 30
35