Maintenance Mode - SATO CL612e Service Manual

Section 7. Factory Resets
7.2 Factory Settings/Test Print
To reset the printer to the factory settings, perform the following steps.
Caution: Resetting the printer will clear all registers.
STEP
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Page 7-2
PROCEDURE
Record all current dip switch positions, then place all switches in the O..
position.
Place the DSW2-4 in the ON or up postion.
Press the LINE and .EED key while simultaneously turning ON the power
switch. When the printer beeps, release the keys. The following screens will
appear.
initializing
rom v00.00.00.00
Place the DSW-4 in the O.. postion and the following screen will appear.
Press the .EED key to display the next screen.
Press the LINE key once to change the message from NONE to ALL.
Press the .EED key to clear the EEPROM. After a pause, the next screen will
appear.
Select the print label size by pressing the LINE key. The default is LARGE.
Press the .EED key for a test print. Press the .EED key again to stop printing.
test print
press feed key
Verify that the counters on the test print have reset to 0.0 km.
Power O.. the printer and confirm that all switches are in the O.. or down
position.
SATO CL608e/CL612e Service Manual

maintenance mode

dipsw2-4 on->off
factory mode
counter clear
none
counter clear
all
print size
small large
Warning: This test activates all the heating
elements on the print head and therefore
should be used for testing purposes only with
full width labels to avoid damaging the print
head.
PN 9001079
Rev. B