Kyocera ECOSYS M6035cidn Operation Manual page 297

Setup and Registration (System Menu) > System Menu
Item
Auto Color Correction
Correcting Black Line
Display Brightness
Color Registration
Drum Refresh
Calibration
Laser Scanner Cleaning
Service Setting
This setting allows you to adjust the detection level used by the machine to determine whether
the original is color or black and white during Auto Color Mode. Setting a lower value will result
in more originals being identified as color, while a larger value will tend to increase the number
of originals being identified as black and white.
Value: 1 (Color), 2, 3, 4, 5 (B & W)
Correct fine lines (streaks caused by contamination), which may appear on the image, when
the document processor is used.
Value
Off: No correction performed. Select this when you want to reproduce fine lines in the
original more clearly than with [On (Low)].
On (Low): Correction performed.
On (High): Select this item if a streak remains after using [On (Low)]. The reproduction
of fine lines on the original may become lighter than when using On (Low).
Set the brightness of the touch panel.
Value: 1 (Darker), 2, 3, 4, 5 (Lighter)
When first installing the machine or moving it to a new location, color drift during printing may
occur. Use this function to correct the color position of each of cyan, magenta and yellow to
resolve color drift.
Color Registration Procedure (page 10-29)
Remove image blur and white dots from the printout. It takes about 3 minutes. The time
required may vary depending on the operating environment and this process may take time.
Drum Refresh (page 10-34)
NOTE
Drum Refresh cannot be performed while printing. Execute Drum Refresh after the printing is
done.
Adjust color drift or hue of printed image in the most appropriate color.
Calibration (page 10-34)
Remove vertical lines from the printout.
Laser Scanner Cleaning (page 10-34)
Settings for machine maintenance and inspection. This menu is primarily used by service
technicians to perform maintenance.
8-40
Description