Morso 6100 series Installation And Operating Instructions Manual page 14

5. When the chimney is warm after about
5-10 minutes, the door should be closed.
A suitable layer of ember will be formed
after about 15-20 minutes.
6. When ready to reload, use a poker to
spread the embers across the firebox floor,
bringing plenty towards the front of the
stove.
7. Lay three pieces of wood onto the embers.
Leave half an inch or more between each
piece.
Max. fuelload 4,0 pounds/h.
8. Close the door. Leave the primary air
supply fully open.
If it does not light, leave the door slightly
ajar to allow the necessary amount of air
in to ignite the wood.
Close the door again once the wood has
kindled.
9. After a few minutes, adjust the primary air
supply to suit your heating requirements.
Make sure that there is always enough air
to sustain clear, enduring flames when you
reduce the amount of combustion air, and
afterwards.
14