Table of Contents
Advertisement
Power up the server.
8.
Processor
WARNING:
internal system components to cool before touching them.
WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
CAUTION:
configurations must contain processors with the same part number.
CAUTION:
heatsink is removed from the processor after it has been installed.
CAUTION:
processor and a heatsink or a processor socket cover and a heatsink blank.
IMPORTANT:
To remove the processor:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 25).
3.
Remove the access panel
4.
Remove the air baffle
5.
Remove the heatsink ("Heatsink" on page 48).
6.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To reduce the risk of personal injury, electric shock, or damage to the equipment,
To prevent possible server malfunction and damage to the equipment, multiprocessor
The heatsink thermal interface media is not reusable and must be replaced if the
To prevent possible server overheating, always populate processor socket 2 with a
Processor socket 1 must be populated at all times or the server does not function.
("Access
panel" on page 29).
("Air
baffle" on page 29).
Removal and replacement procedures 51
Advertisement
Table of Contents
