HP ProLiant DL560 Gen8 Maintenance And Service Manual page 39

Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove any attached network cables.
3.
Extend the server from the rack (on page 25).
4.
Remove the access panel
5.
Remove the primary PCIe riser cage
6.
Loosen the thumbscrew.
7.
Remove the existing FlexibleLOM.
8.
Using the blue touchpoint tabs, pull the FlexibleLOM toward the front of the server while removing it, to
avoid catching it on the rear chassis.
To replace the component:
Using the blue touchpoint tabs, firmly seat the FlexibleLOM in the slot, and then tighten the thumbscrew.
1.
("Access panel" on page 29).
("PCIe riser cage (primary)" on page 31).
Removal and replacement procedures 39