Front Panel Assembly - HP ProLiant DL560 Gen8 Maintenance And Service Manual

Install the PCIe riser cage
2.
Install the access panel
3.
Slide the server into the rack.
4.
Connect the LAN segment cables.
5.
Connect each power cord to the server.
6.
Connect each power cord to the power source.
7.
Power up the server.
8.

Front panel assembly

WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 25).
3.
Remove the access panel
4.
Remove the serial label pull tab and retain it for the new front panel assembly.
5.
Remove the air baffle
6.
Remove all fan modules
7.
Remove all drives
8.
Disconnect all cables from the front panel assembly.
9.
("PCIe riser cage
("Access panel" on page 29).
To reduce the risk of personal injury, electric shock, or damage to the equipment,
("Access panel" on page 29).
("Air baffle" on page 29).
("Hot-plug fan" on page 37).
("Hot-plug drive" on page 34).
(primary)" on page 31).
Removal and replacement procedures 40