Table of Contents
Advertisement
Access panel
WARNING:
internal system components to cool before touching them.
WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
To remove the component:
Power down the server if performing a non-hot-plug installation or maintenance procedure
1.
down the
Extend the server from the rack (on page 25).
2.
Use a T-15 Torx screwdriver to loosen the security screw on the hood latch.
3.
Lift up on the hood latch handle, and then remove the access panel.
4.
To replace the component, reverse the removal procedure.
Air baffle
WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 25).
3.
Remove the access panel
4.
CAUTION:
Detaching the cable causes any unsaved data in the cache module to be lost.
IMPORTANT:
board installed.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To reduce the risk of personal injury, electric shock, or damage to the equipment,
For proper cooling, do not operate the server without the access panel, baffles,
server" on page 25).
To reduce the risk of personal injury, electric shock, or damage to the equipment,
For proper cooling, do not operate the server without the access panel, baffles,
("Access
Do not detach the cable that connects the battery pack to the cache module.
It is necessary to remove the PCI riser cage only if there is a full-length expansion
panel" on page 29).
Removal and replacement procedures 29
("Power
Advertisement
Table of Contents
