Chapter 5. Operating The Terminal; Introduction; Powering The Pdt 7200; Booting The Terminal - Symbol PDT 7200 series Reference Manual

Introduction

This chapter describes how to perform basic tasks with a terminal that has been configured
and charged. For information on configuring the terminal, see
Terminal.

Powering the PDT 7200

Power for the PDT 7200 is provided by a Li-Ion rechargeable battery pack. Before powering
on the terminal, initialize it and install a new or fully-charged battery pack. Refer to
4, Cradle Setup and Operation
Configuring the Terminal
To power the PDT 7200 on or off, press the
corner.

Booting the Terminal

Warm booting the terminal is similar to performing a CTRL+ALT+DEL on a PC. To warm
boot the terminal, press and hold the
boot timeout value of 16 seconds.
Cold booting the terminal generates a system reset, the same as a power-on boot on a
standard PC. To cold boot the terminal, press and hold the
terminal reboots.

Suspending and Resuming Operation

To suspend or resume operation, press the PWR key
also resume operation from various wakeup sources (if enabled through the application). The
wakeup sources available on the PDT 7200 are listed in
Note: The default for enabling/disabling these wakeup sources depends on
how the terminal is suspended (manual suspend using the PWR key
vs. automatic suspend via timeout). An application can also control
the source of a terminal wakeup, overriding the defaults.
for more information on battery packs. Refer to
for information on initializing the terminal.
icon for at least 6 seconds, but less than the cold
Operating the Terminal
Chapter 6, Configuring the
icon on the display in the upper left-hand
icon for 16 seconds until the
on the PDT 7200. The terminal can
Table 5-1.
Chapter
Chapter 6,
5-3