Midi - pigtronix Echolution 2 Ultra Pro User Manual

E c h o l u t i o n 2 | E c h o l u t i o n 2 D e l u x e

Midi

Every function of the Echolution 2 can be controlled via MIDI.
SETTING THE E2 MIDI CHaNNEL:
1. Power up the E2 while holding down the
switch.
2. After the firmware version number has been displayed, a 'C' will
appear. This indicates that the E2 will enter the MIDI Channel
Selection Menu upon release of the Preset rotary switch
3. Once in this menu, the user can see the current MIDI channel and
change it, if necessary, by turning the Preset Rotary Switch.
*Possible MIDI Channels are 1-16, with tens indicated by an
illuminated decimal point, to the lower right of the number.
i.e. 9 = 9, 0. = 10, 1. = 11
pRESS
4. To select a channel,
continue its boot process.
SUppORTED MIDI COMMaNDS
To load a particular preset, simply send a program change
command with the desired preset number. The E2 will load
that number plus one as the preset. This is because many
"pROGRaM CHaNGE
MIDI controllers send
select program x. ie. The foot controller will send
CHaNGE 00" when you select the footswitch corresponding
to preset 1. If you want preset 00, send 127 as the program.
24 |
p i g t r o n i x . c o m
pRESET
rotary
the Preset rotary switch. The E2 will
x-1" when you
"pROGRaM
MIDI CLOCk OpTIONS
Non-pitched MIDI Tracking: Taps teleport when a new MIDI Tempo
is received. The new MIDI clock will only jump if the change in
tempo is greater than 10 ms. This can be switched on and off
during the boot-up process by holding the Delay Time button.
Enable MIDI Clock In: This allows the E2 to adjust its delay time
in accordance with a MIDI clock connected to the MIDI IN port.
By switching this off, the E2 will ignore the MIDI clock received
in the input and replaces it with its own clock. To toggle the
Enable MIDI Clock setting, press and hold EXP button during
power up.
Note: When MIDI Synced, tapping a new delay length will
quantize the new length to an integer number of MIDI quarter
notes. (i.e. you can change the delay time while remaining
MIDI Synced). To get back to the original delay time, double
tap the Tap Tempo switch.
Enable MIDI Clock Out: This allows the E2 to output its own
MIDI clock taken from its Delay Time knob and pass it out of its
MIDI OUT port. To toggle the Enable MIDI Clock Out setting,
press and hold Special Functions button during power up.
Copy MIDI Clock: This passes the MIDI Clock In, to the MIDI
Clock Out. Even if the E2 is ignoring the MIDI Clock In and
operating on its own delay time, it will still output the MIDI Clock
In. This allows the user to control multiple E2's via MIDI CC's
with different delay lengths. To toggle the Copy MIDI Clock
setting, press and hold Special Effects button during power up.
E c h o l u t i o n 2 | E c h o l u t i o n 2 D e l u x e
Midi
| 25
p i g t r o n i x . c o m