1
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
Connect the projector's AC power cord into an AC
2
outlet. The POWER indicator lights red. Open the lens
3
on the remote control. The POWER indicator lights
green and the cooling fans start to operate. The
preparation display appears on the screen.
4
selected the last time and the lamp control status icon
If there is no signal input when start on the projector,
5
or the current signal is missed while operating the
projector, the Video/PC selection window will be
displayed on the screen, please move the pointer to
input source desired by pressing the Point
input signal guidance window to correct the signal and
connection.
If the projector is locked with a PIN code, PIN code input
Note:
Off is selected in the Display function, the
preparation display will not be shown on the screen
Off is selected in the Display function, the Video/
PC selection window and the input signal guidance
Downloaded From projector-manual.com Viewsonic Manuals
Basic Operation
Turning On the Projector
buttons
Off, the logo will
On2, the input
seconds.
Selected Input Source and Lamp Control
Video
Note:
icons may appear on the screen
depending on the usage state of the
projector.
Video / PC selection window
Project Video
Project Video
Project Computer
Cancel
Input signal guidance window
No signal
Current Input setting:Video
Is signal processed correctly?
Is cable connected properly?
Video / PC selection window
Project Video
Project Computer
Project Computer
Cancel
Input signal guidance window
No signal
Current Input setting:RGB
Is signal processed correctly?
Is cable connected properly?