Suzuki GSX-R1000K5 Service Manual page 220

4-60 FI SYSTEM DIAGNOSIS
Step 3
1) Remove the AP sensor.
2) Connect the vacuum pump gauge to the vacuum port of the
AP sensor.
Arrange 3 new 1.5 V batteries in series 1 (check that total
voltage is 4.5 – 5.0 V) and connect - terminal to the ground
terminal 2 and + terminal to the VCC terminal 3.
3) Check the voltage between Vout 4 and ground. Also, check
if voltage reduces when vacuum is applied up to 400 mmHg
by using vacuum pump gauge. (Below)
 09917-47011: Vacuum pump gauge
09900-25008: Multi-circuit tester set
 Tester knob indication: Voltage ()
Is the voltage OK?
• Red, G/Y or B/Br wire open or shorted to
ground, or poor A, P or S connection.
• If wire and connection are OK, intermittent trou-
ble or faulty ECM.
YES
• Recheck each terminal and wire harness for
open circuit and poor connection.
• Replace the ECM with a known good one, and
inspect it again.
If check result is not satisfactory, replace AP sen-
NO
sor with a new one.
4) After repairing the trouble, clear the DTC using SDS tool.
(4-27)
Output voltage (VCC voltage 4.5 – 5.0 V, ambient temp. 20 –
30 °C, 68 – 86 °F)
ALTITUDE
(Reference)
(ft) (m)
0 0
2 000 610
2 001 611
5 000 1 524
5 001 1 524
8 000 2 438
8 001 2 439
10 000 3 048
ATMOSPHERIC
PRESSURE
(mmHg) kPa
760 100
707 94
707 94
634 85
634 85
567 76
567 76
526 70
3
3
OUTPUT
VOLTAGE
(V)
3.1 – 3.6
2.8 – 3.4
2.6 – 3.1
2.4 – 2.9
V
ECM coupler (Harness side)
(Black) (Gray)