Suzuki GSX-R1000K5 Service Manual page 131

• Set the crankshaft to the conrods and upper crankcase.
• Apply a MOLYBDENUM OIL SOLUTION to the crank pin and
bearing surface.
 MOLYBDENUM OIL SOLUTION

Be sure to clean the conrod big end.
• When fitting the conrod cap, make sure that I.D. code A on
each conrod faces intake side.
• Apply engine oil to the bearing cap bolts.
• Tighten the bearing cap bolt by using a 12 mm, 12 point
socket wrench in the following two steps.
 Conrod bearing cap bolt:
Initial: 37 N·m (3.7 kgf-m, 27.0 lb-ft)
Final : 60° (1/6 turn)
• Apply engine oil to the conrod big end side surfaces.
• Check the conrod movement for smooth turning.
• Apply a MOLYBDENUM OIL SOLUTION to each crankshaft
journal and bearing lightly.
 MOLYBDENUM OIL SOLUTION
ENGINE 3-77
60˚