Suzuki GSX-R1000K5 Service Manual page 141

• Install the generator rotor onto the crankshaft.
• Install the rotor bolt with the washer.
• Hold the generator rotor with the special tool and tighten its
bolt to the specified torque.
 09930-44520: Rotor holder
 Generator rotor bolt: 120 N·m (12.0 kgf-m, 87.0 lb-ft)
GENERATOR COVER
• Apply SUZUKI BOND lightly to the mating surfaces at the
parting line between the upper and middle crankcases as
shown.
 99104-31140: SUZUKI BOND "1207B" (USA)
99000-31140: SUZUKI BOND "1207B" (Others)
• Install the dowel pins 1 and new gasket 2.

Use a new gasket to prevent oil leakage.
• Install the generator cover and tighten the generator cover
bolts to the specified torque.
 Generator cover bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)

Be careful not to pinch the finger between the genera-
tor cover and the crankcase.

Use a new gasket washers to prevent oil leakage.
NOTE:
Fit the gasket washers to the bolts A.
• Install the CKP sensor 3.
ENGINE 3-87