Installing The Print Drum - Riso RZ 970 Series User Manual

Installing the Print Drum

1
Place the Print Drum on the Rail.
Align the mark on the Print Drum with the
mark on the guide, and place the Print Drum hori-
zontally onto the guide.
Note:
• If the Print Drum was manually rotated, be sure
to turn it back so that
after it is placed on the guide.
2
Return the Print Drum to its original
position.
Push the Print Drum in as far as it will go, and then
close the Front Cover.
and marks align,
Replacing Consumables
Important!:
• Do not grasp the Print Drum Handle when
pushing in the Print Drum.
Tip:
Changing the Drum Type
When you install a different type of Print Drum, the
Confirm Drum Type screen appears.
Ready to Make Master
F17
Basic Selections Functions
!!The Print Drum Type
has been Changed!!
Select the Current
Print Drum Type
A3 Drum
OK
P.1/3
1)
Select the type corresponding to the installed
Print Drum.
2)
Touch [OK].
The Print Drum type is confirmed and printing
is enabled.
Important!:
• You will not be able to print until the Print
Drum type is confirmed.
• If you install a non-approved Colour Drum,
the message "Wrong-Type Print Drum
Installed Replace with Correct Type" is dis-
played. Install a Colour Drum specifically
approved for use with this machine.
Replacing the Print Drum (Colour Change)
Admin.
A4-R Drum
215