Elation ELAR DW BRICK Instruction Manual page 21

9.2 "SET" – Fixture Personality Settings:
These functions set specific running modes and operating parameters.
<CHAN> DMX Mode settings
This function allows the fixture to run in different DMX channel modes. Two modes are
available; 5 channel, 10 channel. See "DMX Traits" beginning on
explanation of the different DMX modes.
<FAIL> DMX Fault Protection
This function dictates how the fixture will operate in the event DMX signal is suddenly
lost while operating in DMX mode. The three fail safe modes are; 1) "OFF" which will
blackout all light output. 2) "HOLD," which will hold the last DMX command, or 3 "AUTO,"
which will put the fixture in sound-active mode.
<DFSE> - Restore Default
This function is used to restore the factory settings of the device. All settings will be set
back to the default values (shaded). Any edited scenes will be lost.
<POHO> - Power on to preserve the MANL settings
This function will preserve all the manual setting that are made in the "MANL" menu
section. If this function is not activated all manual settings will be lost once the fixture is
tuned off.
<VER> Software Version
This function will display the current firmware version.
9.3 "MANL" – Manual Fixture Settings:
This function allows the each of the ten DMX channels to be controlled manually. This
will allow the fixture to be preset to a specific color or built-in program without the use of
a DMX console.
©Elation Professional, Los Angeles Ca. 20
ELAR DW BRICK ™
page 28 for a detailed
www.ElationLighting.com