Elation ELAR DW BRICK Instruction Manual page 16

fixture. That means changing the settings of one channel will only affect the selected fixture.
In the case of the ELAR DW BRICK™, which is a 5 channel fixture (default), you
should set the starting DMX address of the first unit to 1, the second unit to 6 (5 + 1),
the third unit to 11 (6 + 5), and so on.
Note: During start-up the ELAR DW BRICK ™ will automatically detect whether a DMX data
signal is being received or not. If a DMX data signal is being received, the display will show
"A.XXX" (XXX representing the actual DMX address). If the fixture is not receiving a DMX
signal the display will flash "A.XXX" (XXX representing the actual DMX address).
If your fixture is connected to a DMX controller and the display is flashing (not receiving a
DMX signal), please check the following:
- The 3-pin or 5-pin XLR plug (cable with DMX signal from controller) may not be
connected or is not inserted completely into the DMX input jack.
- The DMX controller is switched off or defective.
- The DMX cable from the controller merging with included IP Rated Cable adapter is
not connected securely
- The DMX cable or connector is defective.
- A DMX terminator has been inserted into the last fixture in your DMX chain.
©Elation Professional, Los Angeles Ca. 15
ELAR DW BRICK ™
www.ElationLighting.com