Table of Contents
Advertisement
9. Route the High Cable (73) under the welded tube on
the Press Frame (12). Wrap the Cable around a 4"
Pulley (35) in the direction shown. Attach the Pulley
to the Press Frame (12) with a 3/8" x 8 1/2" Bolt (59)
and a 3/8" Nylon Locknut (50).
Wrap the High Cable (73) around another 4" Pulley
(35). Attach the Pulley inside the indicated slot in the
Main Upright (3) with a 3/8" x 2 1/2" Bolt (54), two
3/8" Flat Washers (55), two 5/8" x 1/2" Pulley
Bushings (42), and a 3/8" Nylon Jamnut (63).
10. Wrap the High Cable (73) around a 4" Pulley (35) in
the direction shown. Attach the Pulley to the Press
Frame (12) with a 3/8" x 8 1/2" Bolt (59) and a 3/8"
Nylon Locknut (50).
Route the High Cable (73) back through the slot in
the Main Upright (3).
11. Wrap the High Cable (73) around a 4" Pulley (35).
Attach the Pulley inside the slot in the Main Upright
(3) with a 3/8" x 2 1/2" Bolt (54), two 3/8" Flat
Washers (55), two 5/8" x 1/2" Pulley Bushings (42),
and a 3/8" Nylon Jamnut (63).
9
35
42
55
63
12
10
73
Slot
50
11
35
73
63
42
55
9
42
54
55
59
35
50
Slot
73
59
35
12
3
55
42
54
3
Advertisement
Table of Contents
