Table of Contents
Advertisement
12. Disassemble the pre-assembled Pulley Plates (31).
Wrap the High Cable (73) around a 4" Pulley (35).
Attach the Pulley and a Cable Trap (44) to the upper
set of holes in the indicated ends of the Pulley Plates
(31) with a 3/8" x 1 3/4" Bolt (60) and a 3/8" Nylon
Jamnut (63). Make sure the Cable is in the groove
of the Pulley and that the Cable Trap is oriented
to hold the Cable in place.
Set the remaining 4" Pulley (35), 3/8" x 1 3/4" Bolt
(60), Cable Trap (44), and 3/8" Nylon Jamnut (63)
aside. These parts will be used in step 19.
13. IMPORTANT: If you purchased the optional leg
press accessory (NTSA03991), please disregard
steps 14 and 15 in this manual. To assemble the
accessory, refer the user's manual accompanying
it. After you have assembled the accessory, refer
back to this manual and continue with step 16 on
page 11.
Route the High Cable (73) up through the indicated
slot in the Top Frame (1).
Wrap the High Cable (73) over a 4" Pulley (35).
Route the High Cable back down through the slot in
the Top Frame (1).
Attach the 4" Pulley (35) inside the slot in the Top
Frame (1) with a 3/8" x 2 1/2" Bolt (54), two 3/8" Flat
Washers (55), two 5/8" x 1/2" Pulley Bushings (42),
and a 3/8" Nylon Jamnut (63).
14. Detach the pre-assembled 4" Pulley (35) and Cable
Trap (44) from the Pulley Bracket (91).
Attach the Pulley Bracket (91) to the indicated hole in
the Top Frame (1) with a 1/4" x 3 3/4" Bolt (53), two
1/4" Flat Washers (71), and a 1/4" Nylon Locknut (25)
as shown. Make sure that the tab on top of the Pulley
Bracket fits into the hole in the Top Frame as shown
in the inset drawing.
Attach the 4" Pulley (35) and the Cable Trap (44) to
the top hole in the Pulley Bracket (91) with the 3/8" x
1 3/4" Bolt (60) and the 3/8" Nylon Jamnut (63).
12
44
35
31
These adjustment
holes must be at
60
the bottom
13
63
55
42
1
14
91
1
63
Tab
10
63
31
73
35
Slot
42
55
73
53
Top Hole
71
71
25
44
60
35
54
Advertisement
Table of Contents
