Power Supply Failure - Supero 6028R-TT User Manual

6-5 Power Supply
The SuperServer 6028R-T/TT has a single 650 watt power supply. This power
supply module has an auto-switching capability, which enables it to automatically
sense and operate at a 100V to 240V input voltage.

Power Supply Failure

If the power supply fails, the system will shut down and you will need to replace
the power supply unit. Replacement units can be ordered directly from Supermicro.
See contact information in Chapter 1.
Removing/Replacing the Power Supply
Replace the failed power supply module with the same model, which can be ordered
directly from Supermicro (see Contact Information in the Preface).
1. First shut down the system, then unplug the AC power cord from the power
supply module.
2. Remove the chassis cover by pressing the two release buttons on the top of
the chassis (near the front) then push the chassis top rearward about one
inch and lift it off.
3. To remove the failed power supply, remove the screws that secure its sides to
the bottom of the chassis and then pull it straight out.
4. Replace the failed module with another power supply unit.
5. Install the new power supply module.
6. Secure the power supply with the screws you removed previously and finish
by plugging in the AC power cord.
Chapter 6: Advanced Chassis Setup
6-9