Information Led; Drive Carrier Leds - Supero 6028R-TT User Manual

Information LED

This LED will be solid blue when the UID function has been activated.
When this LED flashes red, it indicates a fan failure.
When red continuously it indicates an overheat condition, which may be caused by
cables obstructing the airflow in the system or the ambient room temperature being
too warm. Check the routing of the cables and make sure all fans are present and
operating normally. You should also check to make sure that the chassis covers
are installed. Finally, verify that the heatsinks are installed properly (see Chapter
5). This LED will remain flashing or on as long as the indicated condition exists.
3-4

Drive Carrier LEDs

Each drive carrier has two LEDs:
•
Green: When illuminated, the green LED on the drive carrier indicates drive
activity. A connection to the SATA backplane enables this LED to blink on and
off when that particular drive is being accessed. Please refer to Chapter 6 for
instructions on replacing failed SATA drives.
•
Red: When this LED flashes it indicates the drive is rebuilding. When solid on
it indicates a drive failure. If a drive fails, you should be notified by your system
management software. Please refer to Chapter 6 for instructions on replacing
failed drives.
Chapter 3: System Interface
3-3