Installing the Server into a Telco Rack
If you are installing the SuperServer 6028R-T/TT into a Telco type rack, follow the
directions given on the previous pages for rack installation. The only difference in the
installation procedure will be the positioning of the rack brackets to the rack. They
should be spaced apart just enough to accommodate the width of the telco rack.
Figure 2-4. Installing the Server into a Telco Rack
Note: figures are for illustrative purposes only. Servers should always be installed
in racks from the bottom up.
Stability hazard. The rack stabilizing mechanism must be in place, or the
rack must be bolted to the floor before you slide the unit out for servicing.
Failure to stabilize the rack can cause the rack to tip over.
Chapter 2: Server Installation
2-7