Table of Contents
Advertisement
S
S
UPER
ERVER 6028R-T/6028R-TT User's Manual
5-5
Installing Memory
Warning: Exercise extreme care when installing or removing DIMM modules to prevent
any possible damage.
Memory Support
The X10DRi/X10DRi-T supports up to 1 TB of DDR4-2133/1866/1600/1333 RDIMM
ECC memory (or 2 TB of LRDIMMs). Use memory modules of the same type
and speed. See the following tables for memory installation. Please refer to the
Supermicro web site for possible updates to supported memory.
DIMM Installation
Installing Memory Modules
1. Insert the desired number of DIMMs into the memory slots starting with DIMM
#P1-DIMMA1. When populating two DIMM modules within a channel, always
start with Bank1 first. For optimal memory performance, please install a pair
(or pairs) of memory modules of the same type and speed with a maximum of
12 modules (see the Memory Installation Table below).
2. Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to avoid installing incorrectly (see Figure 5-3).
3. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules.
To Install: Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Figure 5-3. DIMM Installation
Notch
Release Tab
Top View of DIMM Slot
5-8
Front View
Note: Notch should
align with the recep-
tive key point on
the slot.
Notch
Release Tab
Advertisement
Table of Contents
