Using The Function Button; Displaying Internal Test Pattern; Using The Status Function - Panasonic PT-DZ21K2 Operating Instructions Manual

Chapter 3 Basic Operations — Operating with the remote control
Note
f Refer to the [POSITION] menu → [ASPECT] (x page 91) for details.

Using the function button

The <FUNCTION> button of the remote control can be used as a simplified shortcut button by assigning the
following functions: [P IN P], [SUB MEMORY], [SYSTEM SELECTOR], [SYSTEM DAYLIGHT VIEW], [FREEZE],
[WAVEFORM MONITOR], [LENS MEMORY LOAD], [LEFT/RIGHT SWAP], [PROJECTION METHOD]
button
1) Press the <FUNCTION> button.
Note
f [LEFT/RIGHT SWAP] can be assigned only for PT-DZ21K2, PT-DS20K2.
f Assignment of the function is performed from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON] (x page 139).

Displaying internal test pattern

The projector has eight types of internal test patterns to check the condition of the projector body. To display test
patterns, perform the following steps.
button
1) Press the <TEST PATTERN> button.
2) Press qw to select the test pattern.
Note
f Setting is also available from the [TEST PATTERN] (x page 146) menu.
f Settings of position, size, and other factors will not be reflected in test patterns. Make sure to display the input signal before performing
various adjustments.

Using the status function

Display the status of the projector.
button
1) Press the <STATUS> button.
f The [STATUS] screen is displayed.
Note
f This can be displayed from the [PROJECTOR SETUP] menu → [STATUS] (x page 137).
74 - ENGLISH
STATUS
PROJECTOR TYPE
DZ21K2(123456789012)
PROJECTOR RUNTIME 3h
LAMP1
1h/ ON/
LAMP2
1h/ OFF/
LAMP3
1h/ OFF/
LAMP4
1h/ OFF/
INTAKE AIR TEMP.
24°C/75°F
29°C/84°F
OPTICS MODULE TEMP.
28°C/82°F
EXHAUST AIR TEMP.
COOLING CONDITION
AUTO - FLOOR
ATMOSPHERIC PRESSURE
1013hPa
SELF TEST
NO ERRORS
SEND E-MAIL
ENTER
CHANGE EXIT
MENU
1/6