Panasonic PT-DZ21K2 Operating Instructions Manual page 61

Chapter 3 Basic Operations — Switching on/off the projector
Initial setting (installation setting)
Set [PROJECTION METHOD] depending on the installation mode. Refer to "Installation mode" (x page 33) for
details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu →
[PROJECTION METHOD].
1) Press qw to switch the setting.
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (standby mode)
Set the operation mode during standby mode. The factory default setting is [NORMAL], which allows you to use
the network function during standby mode. To keep power consumption low during standby mode, set this function
to [ECO]. After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu →
[STANDBY MODE].
1) Press qw to switch the setting.
2) Press the <ENTER> button to proceed to the initial setting.
Note
f The preceding initial setting screen is displayed when the projector is switched on for the first time after purchase. When [ALL USER DATA]
is executed from the [PROJECTOR SETUP] menu → [INITIALIZE], the [STANDBY MODE] setting before execution is displayed.
INITIAL SETTING
PROJECTION METHOD FRONT/FLOOR
Change the projection method if the screen display is
upside down or inverted.
CHANGE
SET
ENTER
INITIAL SETTING
STANDBY MODE NORMAL
When set to ECO, network functions and SERIAL OUT
terminal, and some RS-232C commands are not
available during standby.
CHANGE
SET
ENTER
2/6
3/6
ENGLISH - 61