System Menu - Kyocera FS-6025MFP User Manual

LE 04 Maintenance LE 04 Maintenance

System menu

System menu
Auto Color Correction
This setting allows you to adjust the detection level used by the machine to determine whether
the original is color or black and white during Auto Color Mode. Setting a lower value will result
in more originals being identified as color, while a larger value will tend to increase the number
of originals being identified as black and white.
Value: 5 (B & W), 4, 3, 2, 1 (Color)
Correcting Black Line Correcting Black Line
Correct fine black lines (black streaks), which may appear on the copies, when the document
processor is used.
Value:
Off: No correction
On (Low): Correction performed. The reproduction of the image becomes lower when using OFF.
On (High):Correction performed. Select this item if the black streak remains after using On (Low).
The reproduction of the image becomes lower when using On (Low).
Display Brightness p y g
Set the brightness of the touch panel.
Value: 1 (Darker), 2, 3, 4 (Lighter)
Gray Adjustment
(see page 8)
Drum Refresh 1
Use this mode when images are blurred or smeared. This takes about 90 seconds. Press [Start] to
perform Drum Refresh.
Drum Refresh 2
Use this mode when white spots appear on images. Takes about 90 seconds. U thi d h hit
To use [Drum Refresh 2], load Ledger or A3 size paper into the multi purpose tray. Press [Start]
to perform Drum Refresh.
When you run [Drum Refresh 2], the machine makes a vibrating sound for about 90 seconds
until drum refreshing is completed. The toner soiling on the ejected paper is normal and does
not indicate a fault.
Auto Drum Refresh Auto Drum Refresh may be executed when the machine is turned on or has recovered
from the low power mode or sleep mode. Auto Drum Refresh is executed automatically to keep
t e best the best image quality by monitoring its peripheral temperature and humidity. age qua ty by
Short: maximum 180 seconds
Normal: maximum 360 seconds
Long: maximum 450 seconds
When an error state such as condensation is detected, [Normal] and [Long] may take a maximum of 630
seconds
DP Adjustment.
Adjust scan action of the document processor. Place the adjustment original in the document processor.
Service Adjustment:
• Switched off units can be activated
• Reset of maintenance counter
• Adjustment of Center Position of cassettes
MPF and Duplex MPF and Duplex
• Start of the developer mode.
t i
o to g ts pe p e a te pe atu e a d u
T k b t 90 d
d ty
Maintenance
Enable Repaired Unit