Switching On The Projector; Making Adjustments And Selections - Panasonic PT-DZ21KU Operating Instructions Manual

Switching on/off the projector
3) 5) 4)
8) 10) 11) 12)
6) 9)

Switching on the projector

Install the projection lens before switching on the
projector. ( page 45)

Remove the lens cover first.
1) Connect the power plug to an outlet.
(AC 200 V - 240 V 50 Hz/60 Hz)
2) Press the <ON> side of the <MAIN
POWER> switch to turn on the power.
▶
z The power indicator <ON (G)/STANDBY (R)>
will light in red, and the projector will enter the
standby mode.
3) Press the power on < > button.
▶
z The power indicator <ON (G)/STANDBY (R)>
will light in green and the image will soon be
projected on the screen.
Attention
z Using the projector while the lens cover is attached
may cause the device to heat up and result in a fire.
Note
z If the projector is switched on at about 0°C (32°F),
a warm-up period of approximately five minutes
may be necessary until a projection is displayed.
The temperature indicator <TEMP> is lit during the
warm-up period. When the warm-up is completed,
the temperature indicator <TEMP> turns off and the
projection starts. Refer to "Managing the indicated
problems" ( page 146) for the indicator status.

z If the operating environment temperature is low and
warm-up takes more than 5 minutes, the projector
will judge that a problem has occurred and the
power will automatically be set to stand-by. If this
happens, increase the operating environment
temperature 0°C (32°F) or higher, turn off the main
power, and then turn on the power again.
z If the menu [PROJECTOR SETUP] → [STANDBY
MODE] ( page 109) is set in the [ECO] menu,

display will start approximately 10 seconds later
compared to when [NORMAL] is selected.
52 - ENGLISH
7) 1)
Making adjustments and
selections
It is recommended that images are projected
continuously for at least 30 minutes before the focus
is adjusted.
4) Press the <FOCUS> button to roughly
5) Set the projection method using
6) Press the input selection (<RGB1>,
7) Adjust the front and back, and sideway
8) Press the <SHIFT> button to adjust the
9) If the input signal is RGB, press the
10) Press the <ZOOM> button to adjust
11) Press the <FOCUS> button again to
12) Press the <ZOOM> button again to
3)
5)
4) 11)
2)
adjust the focus of the image.
( page 54)

[PROJECTION METHOD] (
and [COOLING CONDITION] (
on the menu.
▶
z Refer to "Navigating through the menu"
( page 63) for the operation of the menu

screen.
<RGB2>, <DVI-D>, <VIDEO>, <HDMI>,
<SDI 1/2>) buttons to select the input
signal. ( page 60)

(SDI input is only PT-DZ21KU, PT-DS20KU)
tilt of the projector with the adjustable
feet. ( page 44)

position of the image.(
<AUTO SETUP> button. (
the size of the image to match the
screen. ( page 54)

adjust the focus.
adjust the zoom and the size of the
image to match the screen.
9)
6)
8)
10) 12)
page 102)

page 103)

page 54)

page 61)
