Start-Up Display - Panasonic PT-DZ21KU Operating Instructions Manual

Start-up display

Start-up display
When the projector is switched on for the first time after purchase as well as when [ALL USER DATA] (
in [INITIALIZE] is executed, the focus adjustment screen is displayed after projection starts, then the [INITIAL
SETTING] screen is displayed. Set them in accordance with circumstances.
In other occasions, you can change the settings by menu operations.
■ Focus adjustment ▶
Adjust the focus to display the menu screen clearly.
You may also need to adjust the zoom and shift.
Refer to "Adjusting the focus, zoom, and shift"
( page 54) for details.

1) Press ▲▼◀▶ to adjust the focus.
LENS
FOCUS
FOCUS POSITION
ADJUST
2) Press the <MENU> button to proceed
to the initial setting.
■ Initial setting (display language) ▶
Select the language to show on the screen. (
After completed the initial setting, you can change the
display language from the [DISPLAY LANGUAGE]
menu.
1) Press ▲▼ to select the desired
language.
2) Press the <ENTER> button to proceed
to the initial setting.
22 - ENGLISH
+0
page 84)

■ Initial setting (installation setting 1) ▶
Set [PROJECTION METHOD] depending on the
projection method. Refer to "Projection method"
( page 30) for details.

Set [HIGH ALTITUDE MODE] to [ON] when using the
projector at elevations of 1 400 m (4 593 ft) or higher
and lower than 2 700 m (8 858 ft) above sea level.
After completed the initial setting, you can change the
settings of each item from the [PROJECTOR SETUP]
menu.
1) Press ▲▼ to select an item.
2) Press ◀▶ to switch the setting.
INITIAL SETTING
PROJECTION METHOD
When PROJECTION METHOD is changed, confirm that
COOLING CONDITION is set correctly.
HIGH ALTITUDE MODE
Switch to HIGH ALTITUDE MODE "ON" if over 1400m
(4593Ft).
MENU SELECT
SET
ENTER
3) Press the <ENTER> button to proceed
to the initial setting.
page 117)

FRONT/FLOOR
OFF
CHANGE