Panasonic PT-DZ21KU Operating Instructions Manual page 108

[PROJECTOR SETUP] menu
▶
z Error details
Error message
[Exceed maximum
number of projectors.]
[Please check the
COMMAND CONTROL
setting.]
[Please check the
USER NAME and
PASSWORD in the
COMMAND CONTROL
setting.]
[Cannot apply
BRIGHTNESS
CONTROL. Please
check projector status.]
[Brightness Sensor
Error]
*1: "Multi Projector Monitoring & Control Software" is included
in the attached CD-ROM.
Note
z Check the following when a projector to be
connected is not listed.
–▶Is there a device on the network with the same IP
address?
–▶Is a LAN cable connected correctly? (
–▶Is the projector subnet identical?
–▶Is [LINK] set to the same group?
z To change a projector name, refer to [NETWORK
SETUP] ( page 128), or [Network config] page

( page 137).

108 - ENGLISH
Remedy
z Set no more than eight
projectors in one group.
z Use a computer and
the dedicated "Multi
Projector Monitoring &
Control Software" *1 to
connect nine or more
projectors.
z Set the on-screen menu
[NETWORK CONTROL]
[COMMAND CONTROL]
to [ON] for the projector
in error.
z Set the [NETWORK
CONTROL] [COMMAND
PORT] of all projectors
to be connected to the
same value.
z Set the same character
string to the [User
name] and [Password]
that has Web control
administrator rights
for all projectors to be
connected.
z The projector is in
standby status. Switch
on the projector.
z There is a problem with
the luminance sensor.
If the problem is not
corrected by turning off
the power and turning it
on again, consult your
dealer.
page 130)

▶
zWhen [MODE] in [BRIGHTNESS
CONTROL SETUP] is [PC]
(1) Displays the name of the projector in question.
(2) Uses color to display status.
Green: There is margin for brightness correction.
Yellow: There is less margin for brightness correction.
Red: An error occurred in luminance control.
■ Example steps to adjust ▶
luminance control
The steps exemplify an adjustment to link the
brightness of eight projectors connected in a network.
1) Use a LAN cable to connect all
projectors to a hub. (
2) Switch on all projectors.
3) Set [LAMP SELECT] to either [DUAL]
or [SINGLE] for all projectors.
4) Set [MODE] in [BRIGHTNESS
CONTROL SETUP] to [OFF] and
[APPLY].
5) Set [SUBNET MASK] of the projectors
to the same value, and [IP ADDRESS]
of each projector to a different value
so that the network can communicate.
6) Wait at least eight minutes until the
lamp brightness becomes steady.
7) Set all items in the [PICTURE] menu of
all projectors to the same values.
8) To match colors, adjust [COLOR
MATCHING].
9) Display the internal test patterns of all
projectors in "completely white".
page 130)
