Table of Contents
Advertisement
For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.6 INSTALL MOTION CONTROL LEVERS
3.6.1
MOTION
CONTROL
LEVER
3.7 POSITION DISCHARGE CHUTE.
3.7.1
3.8 SERVICE ENGINE.
3.9 SERVICE ENGINE COOLANT
Loosen and remove the two (2) 3/8"x1" bolts and spring disk washers which attach
the motion control levers to the control arm shafts for shipping and the two (2) 3/8"
x 1" bolts and spring disk washers which are screwed into the control arm shafts.
a)
Install the left motion control lever onto the control arm shaft (See Figure 5) on
the left side of the console. Place the lever (with the mounting plate towards the
rear) on the outside of the control arm shaft and secure with the bolts and
washers. Position the lever so the bolts are in the center of the slots on the lever
mounting plate and tighten until snug. Repeat on opposite side of unit.
NOTE: There are two lever height options available. Place the levers in the top
two holes to increase height of the levers, or the bottom two holes to decrease
the height of the levers.
If the levers do not align with each other when in the neutral position (See Figure
6), loosen the hardware and make the appropriate adjustment by sliding/tilting the
lever(s) forward or backward until properly aligned and tighten hardware.
MOUNT PLATE TO
THE REAR & OUTSIDE
OF ARM SHAFT
FIGURE 5
CONTROL ARM SHAFT
b)
If the ends of the levers hit against each other while in the drive position (levers
rotated in as far as possible), make adjustments by moving the levers outwards
to the neutral lock position and carefully bend them outward. Move them back to
the drive position and check for clearance, repeat if necessary.
Loosen two (2) 5/16" nyloc nuts attaching discharge chute. Lower the discharge
chute into position. Retighten nyloc nuts until chute is snug but can pivot freely.
Engine is shipped with oil; check oil level and if necessary and fill to the
appropriate level with oil as specified in Engine Owner's Manual.
Machine is shipped filled with engine coolant.
www.mymowerparts.com
LEVERS IN
ALIGNMENT
LEVER ALIGNMENT
- 17 -
FIGURE 6
Advertisement
Table of Contents
