Exmark Laser Z XP Operator's Manual page 38

Hide thumbs Also See for Laser Z XP:
Table of Contents

Advertisement

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
See Section 5.1.16 c) for special lubrication instructions on the front caster pivots and
Section 5.1.17 for special lubrication instructions on the front casters wheel hubs.
No. 6 (Fan Pump Belt Idler Arm)
Access through hole in bumper plate
No. 7 (Pump Drive Belt Idler Arm)
Located Under Seat
5.1.17 Lubricate caster wheel hubs:
FITTING
LOCATIONS
1. Front Caster wheel hubs
2. Front Caster Pivots
3. Height Adj. Shaft Bearings
4. Deck Drive Belt Idler Arm
5. Brake Brackets
6. Fan Pump Belt Idler Arm
7. Wheel Drive Pump Belt Idler Arm
8. Deck Rear Struts
9. Mule Drive Belt Idler Arms
c)
Lubricate front caster pivots once a year. Remove hex plug and cap. Thread
grease zerk in hole and pump with grease until it oozes out around top
bearing. Remove grease zerk and thread plug back in. Place cap back on.
Service Interval: Once Yearly
a)
Stop engine, wait for all moving parts to
stop, and remove key.
b)
Remove caster wheel from caster forks.
c)
Remove seal guards from the wheel hub.
d)
Remove one of the spacer nuts from the
axle assembly in the caster wheel. Note
that thread locking adhesive has been
applied to lock the spacer nuts to the
axle. Remove the axle (with the other
spacer nut still assembled to it) from the
wheel assembly.
e)
Pry out seals, and inspect bearings for
wear or damage and replace if necessary.
f)
Pack the bearings with a NGLI grade #1 multi-purpose grease.
g)
Insert (1) bearing, (1) new seal into the wheel.
NOTE: Seals (Exmark PN 103-0063) must be replaced.
h)
If the axle assembly has had both spacer nuts removed (or broken loose),
apply a thread locking adhesive to (1) spacer nut and thread onto the axle
with the wrench flats facing outward. Do not thread spacer nut all of the way
www.mymowerparts.com
LUBRICATION CHART
INITIAL
PUMPS
∗0
∗0
1
1
1
1
1
1
1
- 33 -
NO. of
SERVICE
PLACES
INTERVAL
∗Yearly
2
∗Yearly
2
5
40 hours
1
Yearly
2
200 hours
40 hours
1
1
Yearly
2
40 hours
2
Yearly
FIGURE 10
CASTER WHEEL ASSEMBLY

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lazer z xp

Table of Contents