Install Drive Wheels; Check Tire Pressure; Install Seat; Install Foot Lift Assist - Exmark Laser Z XP Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983

3.3 INSTALL DRIVE WHEELS

3.3.1

3.4 CHECK TIRE PRESSURE.

3.4.1

3.5 INSTALL SEAT.

3.5.1

3.6 INSTALL FOOT LIFT ASSIST

3.7 INSTALL MOTION CONTROL LEVERS.

3.7.1
Mount drive wheels with the valve stem to the outside of the unit. Secure using
four (4) 1/2-20 wheel nuts (installed on studs in hubs) for each wheel. Torque to
95 ft-lbs (128 N!M).
Check tire pressure in caster and drive tires. Proper inflation pressure for all four
(4) tires is 13 psi (90 kPa). Adjust if necessary.
The seat base frame with adjustable tracks and seat
retaining rod are already attached to the unit. Remove
the suspension seat from front of crate and discard the
hardware. Position the seat with the holes on the
studs in the adjustable tracks; be sure the left and
right tracks are aligned (See Fig.1). Loosen the vinyl
curtain frame at the rear by pushing down and ahead
out of the hole. Secure the seat with four (4) 5/16
whizlock nuts. Reattach the vinyl curtain frame.
Connect the terminal at the end of the wire tied to
the seat frame to the switch in the bottom of the seat.
a) Remove the lift assist lever from the rear deck lift arm or the seat base frame (the lift
assist is fastened in this position for shipping only) and attach to the front deck lift
lever as shown in Fig. 2.
Loosen and remove the two (2) 3/8"x1" bolts and spring disk washers which
attach the motion control levers to the control arm shafts for shipping and the two
(2) 3/8" x 1" bolts and spring disk washers which are screwed into the control arm
shafts.
www.mymowerparts.com
.
FIG. 2
LEVER ALIGNMENT
- 15 -
FIG. 1
SUSPENSION
SEAT INSTALLATION