Install Canister Air Cleaner (Kohler 26 Hp Efi Only); Install Motion Control Levers - Exmark Lazer Z Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.7 INSTALL CANISTER AIR CLEANER. (Kohler 26 HP EFI units only)

3.8 INSTALL MOTION CONTROL LEVERS.

3.8.1
a) Remove air cleaner (with bracket attached) from crate. Keep air cleaner and
mounting bracket together.
b) Remove the top two valve cover mounting screws from both left and right side
engine valve covers. Keep screws for re-attaching air cleaner.
c) Position the air cleaner assembly over the engine, aligning air cleaner bracket
holes with top holes in the valve covers. Reinstall valve cover screws through air
cleaner bracket and torque to 70 in. lb. (4.9 N-m).
d) Remove plastic plugs from air intake elbow on engine and air cleaner hose. Adjust
the air cleaner and hose as required and connect intake hose to air cleaner outlet.
Position and tighten the two hose clamps to secure the hose connections.
e) Secure air cleaner by tightening the tensioning bolt and spring assembly until
ends of clamp are approximately ½" (12.7 mm) apart.
f) Rotate the air intake elbow as needed to create enough clearance between the
filter minder and the oil filler cap to remove and replace the oil filler cap easily.
See Figure 3.
NOTE: The filter minder must clear the lift lug. If necessary, bend the lift lug
towards the back of the machine to gain clearance for the filter minder.
Loosen and remove the two (2) 3/8" x 1" bolts and spring disc washers which
attach the motion control levers to the control arm shafts for shipping and the
two (2) 3/8" x 1" bolts and spring disc washers which are screwed into the
control arm shafts.
www.mymowerparts.com
FIG. 2
LEVER ALIGNMENT
FIG. 3
CONTROL ARM SHAFT
- 18 -