Audionet MAP v2.0 User Manual page 28

If the input signal is a bitstream (like Dolby Digital or DTS), the current bitrate is
displayed as kbps (kbit per second) in the lower right corner of the display. In case of a
PCM input signal information about the usage of emphasis during recording is shown
instead of the bitrate:
recorded using emphasis
EMPH
no emphasis used.
–
After several seconds the display changes. Now the second line provides information
about the output and speaker configuration. If a speaker is available in the current
speaker configuration, and it is supported by the current Listening Mode, the
corresponding letter is printed in the display:
= Left Front
L
= Center
C
= Right Front
R
= Left Surround
LS
= Right Surround
RS
= Back Left
BL
= Back Right
BR
= Back Center, if only one speaker is available in the channel group Back
BC
If a speaker is used by the program material, the corresponding letter is printed inversely
in the display.
If the subwoofer is active, it is displayed by an inverse 'SUB'. Otherwise this symbol is
not printed.
28