Table of Contents
Advertisement
program that is being debugged. Abort should be used to regain
control if the program gets caught in a loop, etc. The target PC and
register contents assist you in locating the malfunction.
Pressing and releasing the ABORT switch generates a local board
condition that causes:
Break
You can generate a ÒBreakÓ by pressing and releasing the BREAK
key on the terminal keyboard. Break does not generate an interrupt.
The only time break is recognized is when characters are sent or
received by the console port. A Break causes:
Often it is desirable to terminate a debugger command prior to its
completion; for example, during the display of a large block of
memory. Break allows you to terminate the command immediately.
A processor interrupt (if enabled)
The target registers (reflecting the machine state at the time
the ABORT switch was pressed) display on the screen
All breakpoints installed in your code are removed
Breakpoint table remains intact
Control returns to the debugger
All breakpoints in your code to be removed
Breakpoint table to be maintained intact
A snapshot to be taken of the machine state if the function
was entered using SYSCALL
The snapshot is accessible to you for diagnostic purposes
Restarting the System
B-9
B
Advertisement
Table of Contents
