Standalone Modem Alarm Input Settings; Table 6: Alarm Trap Option Definitions - Canoga Perkins EdgeAccess Universal Chassis System 2361 T1 User Manual

The EdgeAccess Universal Chassis System
Table 6 describes the function of each trap:
Name
1. All Traps
2 Inactive Link/Modem Traps
3 Electrical AIS
4 Configuration
5 Power Supply
6 Test
7 Link Self Test
8 Power On Self Test
9 Inactive Composite Link

4.4.7 Standalone Modem Alarm Input Settings

The standalone modem allows inputting of alarms from an external device, thus generating a trap,
(if the trap is enabled) when triggered. To enable this feature, do the following:
1. From the Main Menu, type "1" to open the System Configuration screen.
2. Type "3," Link Level Trap Configuration.
3. Look at option 8. If Alarm Input Trap is enabled; the feature is enabled.
4. If Alarm Input Trap is "disabled", type "8," then press the spacebar to "enable" the option.
4-14

Table 6: Alarm Trap Option Definitions

Enables or disables all the traps in this list
Loss of signal received from attached
equipment
"All 1's" signal pattern received from
attached equipment
Incompatibility between local and remote
modem, or between main modem module
and the LIMs attached to it
Failure of power supply in the remote
chassis
Failure of Bit Error Rate Test (BERT) or
failure in the continuous self-test operation
Failure of fiber between Local and Remote
units
Failure of Power-On self test
In a redundant configuration, failure of the
redundant or inactive link .
2361 Modem Users Manual
Function