Installing The New Software; Installing In A Managed Ucs Chassis; Installing Into A Standalone Modem Via Tftp; Figure 47. To Download A Software Revision, Type "3" From The Software Upgrade Screen - Canoga Perkins EdgeAccess Universal Chassis System 2361 T1 User Manual

The EdgeAccess Universal Chassis System

8.3 Installing the New Software

Instructions for installing software into the rackmount modem (in a UCS Chassis) via DMM will
differ from installing into a standalone modem.

8.3.1 Installing in a Managed UCS Chassis

For these instructions, please refer to the DMM users manual.

8.3.2 Installing into a Standalone Modem Via TFTP

This installation is performed over the dial-up network and requires that the standalone modem
has the SNMP option. If this option is not activated, contact Canoga Perkins to activate it.
To upgrade and install the new software version, perform the following: (The following steps
assume that the TCP/IP stack has been activated for this modem.)

Figure 47. To Download a Software Revision, Type "3" From the Software Upgrade Screen

1. From the Main Menu type "6" and press Enter.
2. Use the TFTP feature here to download the software to the inactive flash region of the
modem.
3. Make sure the new firmware file is in the root directory of your TFTP server (The TFTP
server must be running).
4. Type "3." The TFTP Operation Screen appears.
5. Enter the TFTP Server IP Address.
•
Use the default IP address, or
•
Follow the on-screen prompts for saving the IP Address as the default.
6. Enter the filename, for example, 2X6X0173.zip.
2361 Modem Users Manual
for firmware
8-3