Exmark Lazer Z XP Operator's Manual page 34

Hide thumbs Also See for Lazer Z XP:
Table of Contents

Advertisement

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
5.1.11
f)
Clean around oil filter and unscrew filter to remove.
g)
Before reinstalling a new filter, apply a thin coating of fresh clean oil on the
surface of the gasket.
h)
Turn filter clockwise until rubber seal contacts the filter adapter, then tighten
filter an additional 1 full turn.
i)
Clean around oil fill cap and remove cap. Fill to specified capacity and replace
cap. Use oil recommended in engine owner's manual. DO NOT overfill.
j)
Start the engine at idle for 5 minutes. Stop engine and wait three minutes,
then check the oil level. If required, add oil to bring level to the "FULL" mark
on the dipstick. DO NOT overfill.
k)
Check for leaks, including around the oil filter.
Change engine coolant:
Service Interval: 4 years/4000 hours* - Dex-Cool© extended life
* It is recommended to service at whichever interval happens first.
a)
Stop engine, wait for all moving parts to stop, and remove key. Machine
must be positioned on level surface.
b)
Tilt seat up and tilt hood forward to gain access to the cooling area.
POTENTIAL HAZARD
♦ Engine coolant is hot and pressurized.
♦ Radiator and surrounding parts are hot.
WHAT CAN HAPPEN
♦ Spray or steam from hot, pressurized liquid in the
engine cooling system or touching a hot radiator may
cause severe burns.
HOW TO AVOID THE HAZARD
♦ Allow the engine to cool completely before removing
the radiator cap or servicing any component of the
cooling system.
POTENTIAL HAZARD
♦ Engine coolant is toxic.
WHAT CAN HAPPEN
♦ Swallowing coolant can cause poisoning.
HOW TO AVOID THE HAZARD
♦ Do not swallow
♦ Keep out of reach of children and pets.
Drain coolant when engine is cool. Coolant may be drained from the radiator by
loosening the drain cock in the right rear corner. The engine block may be
drained by removing the rear radiator hose and/or by removing the drain plugs
from the engine block. The plugs may be accessed from the right side of the unit
and are located as shown in Figure 6. The 31 HP Daihatsu gas has a hex head
bolt for the drain plug. The 27 HP Daihatsu diesel has a socket head bolt for the
drain plug.
www.mymowerparts.com
coolant (orange color)
WARNING
CAUTION
- 29 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents