Exmark Lazer Z XP Operator's Manual page 33

Hide thumbs Also See for Lazer Z XP:
Table of Contents

Advertisement

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
5.1.8
5.1.9
5.1.10
Run engine at one-third throttle, engage PTO and raise off of seat (but do not
get off of machine) engine must stop after1/2 second has elapsed.
Run engine at one-third throttle, with brake disengaged, move levers in and
raise off seat (but do not get off of machine) engine must stop after 1/2
second has elapsed.
Again, run engine at one-third throttle, brake engaged, and move left
motion control lever in - engine must stop. Repeat again moving the
right lever in, then moving both levers in - engine must stop whether
operator is on seat or not.
NOTE: If machine does not pass any of these tests, do not operate.
Contact your authorized EXMARK SERVICE DEALER.
IMPORTANT: It is essential that operator safety mechanisms be connected
and in proper operating condition prior to use for mowing.
Check for loose hardware.
Service Interval: Daily
a)
Stop engine, wait for all moving parts to stop, and remove key.
b)
Visually inspect machine for any loose hardware or any other possible
problem. Tighten hardware or correct the problem before operating.
Service air cleaner.
Canister type, 2 stage cleaner:
Service Intervals:
First service interval – 50 hrs.
Normal service interval – 100 hrs.
Replacement interval – 600 hrs.
(more often under heavy load or high temperatures).
a)
Stop engine, wait for all moving parts to stop, and remove key.
b)
Tilt seat up to gain access to the air cleaner.
c)
Loosen retaining clips and remove air cleaner compartment cover.
d)
Check paper element. Gently tap the paper element to dislodge any dirt.
DO NOT wash or use pressurized air to clean paper element. Replace if
dirty, bent or damaged.
e)
Reinstall paper element. Position the cover so that the rubber dust ejector
is pointing downward and secure with retaining clips.
Change engine oil:
Service Intervals:
First service interval – 50 hrs.
Normal service interval
– 31 HP Daihatsu Gas units – 200 hrs.
– 27 HP Daihatsu Diesel units – 100 hrs. (yearly if operated
(more often under heavy load or high temperatures).
a)
Stop engine, wait for all moving parts to stop, and remove key.
b)
Tilt seat up and tilt hood forward to gain access to the engine area.
c)
Drain oil while engine is warm from operation.
d)
Remove the oil drain plug. There are two oil drain plugs available. One drain
plug is located at the front of the engine; the other is located on the right side.
Either drain plug can be used. Allow oil to drain then replace the drain plug.
e)
For 31 HP Daihatsu Gas units – Replace the oil filter every oil change.
For 27 HP Daihatsu Diesel units – Replace the oil filter every other oil change.
www.mymowerparts.com
less than 100 hrs.)
- 28 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents