Hdmi Connector - Sony IPELA SNC-VM772R Installation Manual

l NETWORK indicator (Green/Orange)
The indicator lights up or flashes when the camera is
connected to the network.
The indicator is off when the camera is not connected to
the network.
m POWER indicator (Green/Orange)
When power is supplied to the camera, the camera starts
checking the system.
If the system is normal, this indicator lights up in green.
When only the built-in heater is working (the system is
stopped), the indicator lights up in orange.
n LAN
network port (RJ-45)
Connect a commercially available network cable (UTP,
category 5) to communicate with a network or PoE*
system.
For details on connection, see the Instruction Manual of
the power supply equipment.
(*PoE + stands for Power over Ethernet. PoE is compliant
with IEEE802.3af)
o Dome casing
The dome cover is made of polycarbonate. A waterproof
rubber gasket is provided on the joint surface to the unit.
p Safety cord
This cord prevents the dome casing from falling off the
unit.
Bottom
1 2
a Rating label
Shows the name of this camera and its electric rating.
b Nut (
3
/ inches NPT or M27 (2.0 mm (
4
inches)-pitched))
c HDMI connector
Connect the commercially available HDMI cable.
Notes
• To prevent the HDMI cable disconnecting from the
camera (either by its own weight or an external force), it
is recommended to secure it with commercially available
retaining parts, etc.
• When using the HDMI cable, use it at an outside
temperature between 0 ºC to 50 ºC.
d Vent filter
Note
Do not damage the filter and do not cover the hole of the
filter.
e Sealing rubber
When attaching the supplied multi connector cable,
remove the rubber.
f GND
Ground the camera when you install it.
Tip
When connecting the GND from the power input cable, the
GND connection from the GND screw is not necessary.
Note
Use the supplied Screws 3 (M4 × 8)
g Terminal rubber
By removing the terminal rubber, you can confirm the
HDMI connector. When you use the HDMI connector,
remove the rubber.
Note
When you remove the terminal rubber to use the HDMI
3
connector, the water-proof capability of the camera is lost.
Do not use the camera outdoors.
4
5
h Fall-prevention strap
6
Connect to the brackets and prevent the camera from
falling.
7
i Screw
8
9
3
/
32
6