Location And Function Of Part - Sony IPELA SNC-VM772R Installation Manual

Location and Function of
Part
Side
The figure shows the camera without the dome casing.
a Multi connector cable (supplied)
Not connected to the camera at the factory.
Note
Using a device other than the recommended devices may
cause a failure or malfunction.
A Audio cable
The connector with the longer cable (SP) is used for the
line output connector, and the shorter cable (MIC) is used
for the microphone/line input connector.
Switch the microphone input and the line input in the
Video/Audio menu.
For details of the settings, refer to the User's Guide.
• SP terminal (minijack, monaural)
Not used with this unit.
• MIC terminal (minijack, monaural)
Connect a commercially available microphone. This
jack supports pluginpower microphones.
B I/O (Input/Output) cable
This cable is provided with two sensor inputs and two
alarm outputs.
The wires of the cable control the following signals.
Color of wire
Red
White
Black
Yellow
Brown
Green
Blue
◆ For details on each function and required settings, see
the User's Guide.
◆ For the wiring, see "Connecting the I/O Cable" on page
13.
C Power input cable (supplied and connected
to the camera at the factory)
Connect this cable to a 24 V AC or 12 V DC power supply
system.
You can screw an extension cable in the connector tip
attached at the end of the cable. When you use the power
input cable, connect GND to the center of the 3-pin
connector (FG).
D BNC cable
Not used with this unit.
b Base (PAN)
c Camera block
d Infrared LED
Irradiates infrared light.
Notes
• Do not look at the infrared LED for a long time.
• Images may be dark if irradiated at a high temperature
environment.
e LAN cable (RJ-45) (supplied and connected
to the camera at the factory)
Connect this cable to a hub or computer on the 10BASE-T
or 100BASE-TX network using a commercially available
network cable (UTP, category 5).
3
Name
Sensor In 1+
Sensor In 2+
Sensor In – (GND)
Alarm Out 1+
Alarm Out 1–
Alarm Out 2+
Alarm Out 2–