Installing The Camera - Sony IPELA SNC-VM772R Installation Manual

Installing the Camera

1
Wrench
Screw (4 positions)
2
Ceiling
3
1,2
Ceiling
Side
conduit
hole
Ceiling
1
2
Bracket (supplied)
1
Remove the dome casing.
1 Loosen the screws with the wrench (supplied).
2 Pull up and remove the dome casing. When the screw
catches on the screw hole, pull up the screw.
2
Install the supplied bracket on the ceiling or wall.
"O" mark indicates the direction of the conduit hole
(connected to the pipe) of the camera unit. For the screws
to be used, refer to "Mounting screws" (page 8).
3
Attach the fall-prevention strap to the bracket.
1 Hang the strap matching the position between the
bracket and the conduit hole as shown in figure. 3.
2 Rotate the strap 90 degrees to enable the fall-
prevention function.
4
Wire the cables on the bottom.
Wire the supplied LAN cable.
5
Attach the camera unit to the bracket temporarily.
Align the "O" mark of the bracket and "O" mark of the
camera unit, and insert the camera unit into the bracket
until it clicks into place. The camera unit is temporarily
attached to the bracket, and the attached state is as it is even
if you release your hands from the camera unit.
5,6
"O" mark
Note
The camera unit is temporarily attached. The temporary
attachment may come off due to vibrations or shocks.
After attaching temporarily, secure the camera unit to the
bracket with the camera unit mounting screws
immediately.
9
Screw positions