Advertisement
Specifications
XCL-5005
Image device
Standard picture size (H x V)
2448 x 2050 (5,018,400 pixels)
Cell size
Resolution depth
8/10/12 bits/pixel
Lens mount
Digital interface
Standard Camera Link (Base Configuration)/PoCL (Power over Camera Link)
Frame rate
Output data clock
80 MHz (1 Tap)
40 MHz (2 Taps)
Sensitivity
400 lx F5.6 (0dB)
Minimum illumination
1 lx (GAIN +18dB, F1.4)
Gain control
Readout modes
Normal, Binning (1x2),
Partial scan (by 1 line increments)
Shutter speed
Shutter mode
External trigger shuter (Trigger start/Trigger start and exposure duration)
Readout features
Gamma : OFF/ON (Arbitrary setting),
DTL filter (Edge detection/emphasis),
3x3 matrix filter, Binarization
Extended signal output
Power requirements
Power consumption
Dimensions
1
3
/
(W) x 1
3
/
4
Weight
Operating temperature
Storage temperature
Operating humidity
Storage humidity
Vibration resistance
Shock resistance
Supplied accessories
* When RAW data is output, depending on the frame grabber, picture size may be reduced to 2,446 (H) x 2,048 (V).
Dimensions
4-M3
11
/
(8)
3
32
1
/
(44)
4
4-M3
Sony Electronics Inc.
1 Sony Drive
Park Ridge, NJ 07656
www.sony.com/videocameras
IS-1206 (MK10466V1)
XCL-5005CR
2/3-type progressive scan IT CCD
2448 x 2050 (5,018,400 pixels)*
3.45 x 3.45 µm
Raw Color: 8/10/12 bits/pixel
RGB Color: 24bits
C mount
15 fps
80 MHz (1 Tap)
40 MHz (2 Taps, Raw Color only)
2000 lx F5.6 (0dB)
8 lx (GAIN +18dB, F1.4)
0 to +18 dB
Normal, Partial scan (by 2 line increments)
2 to 1/10,000 s
Gamma : OFF/ON (Arbitrary setting)
AWB : OFF/ON (One push)
DVAL/EXPOSURE/GND output (selectable)
DC 12V
Max. 3.8 W
(H) x 2
3
/
(D) inches ( 44 x 44 x 57.5 mm), (excluding protrusions)
4
8
Approx. 4.6 oz (130 g)
23 to 113 °F (-5 to 45 °C)
-22 to 140 °F (-30 to 60 °C)
20 to 80 % (no condensation)
20 to 95 % (no condensation)
10 G (20 to 200 Hz)
70 G
Lens mount cap, Operating instructions
17
/
32
2 (50)
(13)
3
2
/
(57.5)
8
17
/
32
2 (50)
(13)
PIN Assignment &
Connector
■ 12-pin EIAJ connector
Pin No.
1
DC IN (Ground)
2
DC IN
3
ISO GND
4
Store OUT (Isolated)
5
GPIO OUT 1- (Isolated)
6
GPIO OUT 1+ (Isolated)
■ 26-pin connector
Pin No.
1
POWER/INNER_SHIELD (GND)
2
X0- output (signal)
3
X1- output (signal)
4
X2- output (signal)
5
XCLK- output (signal)
6
X3- output (signal)
7
SerTC+ (signal)
8
SerTFG- (signal)
9
TRIG- input (signal)
10
NC
11
NC
12
NC
13
INNER_SHIELD (GND)
PoCL: Pin 1 and pin 26 are used for power.
Standard Camera Link: Pin 1 and pin 26 are used for INNER_SHIELD (GND).
Optional Accessories
13
1
/
/
32
2
(10)
(12)
12-Pin Connector
26-Pin Camera Link Connector
Unit: inches (mm)
Reproduction in whole or in part without written permission is prohibited.
Features and specifications are subject to change without notice.
All non-metric weights and measurements are approximate.
Sony is a registered trademark of Sony Corporation.
All other trademarks are the property of their respective owners.
Pin No.
7
GPIO IN 1+ (Isolated)
8
GPIO OUT 2- (Isolated)
9
GPIO OUT 2+ (Isolated)
10
GPIO OUT 2+ (Isolated)
11
Trigger IN
12
ISO GND
Pin No.
14
INNER_SHIELD (GND)
15
X0+ output (signal)
16
X1+ output (signal)
17
X2+ output (signal)
18
XCLK+ output (signal)
19
X3+ output (signal)
20
SerTC- (signal)
21
SerTFG+ (signal)
22
TRIG+ input (signal)
23
NC
24
NC
25
NC
26
POWER/INNER_SHIELD (GND)
Tripod Adaptor
VCT-ST70I
Isolated type
Weight: Approx. 0.5 oz (14 g)
Dimensions (W x H x D):
1
/
x
/
x 2
/
inches
5
1
3
8
4
8
(40 x 6 x 59 mm)
Camara Adaptor
DC-700
Cables
CCXC-12P02N
CCXC-12P05N
CCXC-12P10N
CCXC-12P25N
©2008 Sony Corporation. All rights reserved.
Printed in U.S.A. 2/08
Advertisement
