Option 3: Wireless Connection Via Wireless Card (Factory Default For Premierwave En Model Only) - Lantronix PremierWave Quick Start Manual

5. Select the appropriate power plug adaptor for your geographical location. Insert it into the slot
on the Universal Power Supply; then plug the power supply into an outlet.
6. Connect the output plug of the power supply to the PremierWave Evaluation Board.
7. Move the power switch on the Evaluation Board to ON. This is the last step in 'connection.'
The PremierWave is ready for configuration.
8. Continue with
Option 3: Wireless connection via Wireless card (factory default for
PremierWave EN model only)
1. Ensure the wireless card is running correctly. Change the wireless card configuration as
follows:
a. Set Network name (SSID) to Lantronix Initial Adhoc Network.
b. Select AdHoc/Peer-to-Peer Mode network.
c. Disable all wireless security (no encryption, no/open authentication).
2. Select the appropriate power plug adaptor for your geographical location. Insert it into the
slot on the Universal Power Supply; then plug the power supply into an outlet.
3. Connect the output plug of the power supply to the Evaluation Board. The final setup should
look like this:
4. Move the power switch on the Evaluation Board to ON. This is the last step in 'connection.'
The PremierWave is ready for configuration.
5. Continue with
PremierWave® Evaluation Board Quick Start
Installing DeviceInstaller on page
Installing DeviceInstaller on page
Connecting a PremierWave Device—Network Method
9.
9.
8