Sanyo DC-D40 Instruction Manual page 14

Backward skip edit recording
This type of recording is the easiest to perform and the tape length setting is not required.
Example: The track 4 will be interrupted.
SIDE A
A
Ei===k::rse
Record from the beainnina of a track.
The track 8 till be interrupted.
.-
1. Select the desired disc.
"SIDE Auto "SIDE B" and recording continues from the beginning of
2. Press the COMP. REC button. Recording starts on side A with track 1.
the last track played.
When the tape automatically reverses, the display changes from
MANUAL RECORDING
1. Select the desired disc.
- When the CD player issettothestopor pause mode during recording,
- For programmed recording, programme the material in advance
the deck B pauses, When CD play is resumed, deck B recording also
(as described under "PROGRAMMED PLAY").
resumes.
2. Press the REC PAUSE button of the deck. (The deck B enters the
- This method produces a gap in recording when the tape reverses.
record pause mode.)
- If the TIME/FADE button is pressed during recording, the sound
3. Press the P!AY/PAUSE button of the CD player. CD recording starts,
begins to fade out from that point (about 10 seconds). The CD player
pauses and the deck B is placed in the record pause mode,
TAPE DUBBING (DECK A to DECK B)
High-speed dubbing
For simple, automatic dubbing in one-half the time, compared to
normal speed dubbing.
Manual (normal-speed) dubbing
For dubbing while listening to the playback from deck A.
- Load the playback tape into deck A and a blank tape into deck B.
- It is recommended to use the same length cassettes in both decks for
the dubbing operation.
- You may listen to any other function (CD, radio etc.) during dubbing,
High-speed dubbing
Press the DUBBING-HIGH button.
The system performs the steps below and automatically starts deck A
playback and deck B recording.
1. Deck A: Tape rewinds.
2. Deck B: Tape rewinds.
3. Deck B: Erases the first few seconds of the tape, then rewinds again,
4. Deck B: Automatically advances the tape past the leader.
The REC PAUSE indicator blinks and the DECK B and D indicators light
as dubbing begins.
Automatic stop during high-speed dubbing
~mode:
When deck A or deck B stops automatically, the other deck will also
stop.
~ mode:
When deck A tape is longer than deck B:
When deck B stops automatically, deck A enters the fast forward
mode, When the end of side A is reached, high-speed dubbing
continues from the beginning of side B,
When deck B tape is longer than deck A:
When deck A stops automatically, deck B erases the tape to the end
of side A. When the end of side A is reached, high-speed dubbing
continues from the beginning of side B.
Before pressing the DUBBING-HIGH button, check that both decks A
and B are in the stop mode.
To stop dubbing, press the button. The tape will not stop during
high-speed dubbing if the REC PAUSE button is pressed.
During high-speed dubbing, normal monitoring is not possible.
During dubbing, the DOLBY NR button has no effect to the copied
tape.
A high-pitched sound maybe recorded if high-speed dubbing is used
near a TV which has been switched on. If this happens, switch off the
TV or place the system at a distance from the TV.
High-speed dubbing must start from the selection 1. To start dubbing
from a position in the middle of the tape, use manual dubbing.
Manual (normal-speed) dubbing
1.
2.
3.
4,
5.
Select "TAPE".
Set the REVERSE lever to=.
Deck B: Locate the tape position where recording will begin,
Deck A: Select b or < (to match the deck B), then locate the
selection of the tape to be dubbed.
Press the REC PAUSE button,
The REC PAUSE and DECK B indicators light and the b or <
indicator blinks.
Note:
Ifthe blinking indicator does not match the desired direction, press the
b or ~ button to change the direction,
Press the DECK button to select deck A.
The DECK B indicator goes out and DECKA indicator lights. The REC
PAUSE indicator blinks.
Press the b or a button whose indicator is blinking. Manual
dubbing starts.
Both decks run in the same direction.
Automatic stop during manual dubbing
If deck A or deck B stops automatically, the other deck will also stop,
-13-