Table of Contents
Advertisement
Using the 8 cm CD tray
The supplied small tray is used for 8 cm discs. It is not necessary to use
an adaptor.
1. Pull one of the disc trays out of the magazine, then remove it.
2. Place an 8 cm disc with the label facing downward on the centre of the
8 cm CD tray.
3. Carefully push the disc tray into the magazine until it locks into place.
Note:
Discs must be loaded into the magazine one at a time. Do not pull
another disc tray out while loading a disc.
Slide the disc tray in and out in a straight motion when loading or
unloading a disc, to prevent damage to the disc.
Do not apply excessive force to the disc tray.
When removing a disc tray, take special care to prevent dropping the
disc.
When loading or unloading a disc, do not apply excessive pressure to
the top or bottom of the magazine, or the disc may be scratched,
For easy removal, store the disc trays in the magazine with their knobs
facing the right and left sides alternately. The knobs for disc numbers
1,3,5,7
and 9 are on the right, while numbers 2,4,6,8,
and t O are on
the left,
Never use 6 cm CDs with snap-on adaptors! This will damage the
inside of the player.
Notes on handling compact discs
Do not expose the disc to direct sunlight, high humidity or high
temperatures for extended periods of time.
Discs should be returned to their cases after use.
Do not apply paper or write anything on the disc surface.
Handle the disc by its edge. Do not touch the playing surface (glossy
side),
Fingerprints and dust should be carefully wiped off the playing
surface of the disc with a soft cloth,
Wipe in a straight motion from the centre to the outside of the disc.
Never use chemicals such as record cleaning sprays, antistatic sprays
or fluids, benzene or thinner to clean compact discs.
Inserting a magazine
1.
Press the top left portion (PUSH-OPEN) on the magazine door to open
it.
2. Before inserting the magazine into the slot, confirm that all disc trays
are locked into position. Using the magazine without all 10 disc trays
may result in a malfunction.
3, Insert the magazine as shown in figure by pressing the centre of the
front edge,
y?
I
4. Close the magazine door.
Removing a magazine
1. Open the magazine door.
2. Press the ~
button. Only half of the magazine will come
slot.
3, Remove the magazine.
out of the
Note:
To prevent damage to the discs, do not turn the magazine upside down.
Precautions
for the magazine
This 10-disc magazine is especially designed for use with SANYO 10-
disc multi-play compact disc playqrs, so other disc magazines cannot
be used with this unit.
Do not place anything except a compact disc in the magazine.
If the magazine will not be used for a long period, store it in its case.
Do not store the magazine in direct sunlight or in areas where it will be
exposed to unusually high temperatures.
Do not disassemble the magazine. It is not user-serviceable.
Be careful not to drop or abuse the magazine.
Do not use cleaners such as benzene, thinner or antistatic spray to
clean the magazine,
Page 6
Hide quick links:
Advertisement
Table of Contents
