Troubleshooting; Power; Recording/Playback - Sony PXW-X200 Operating Instructions Manual

Troubleshooting

Power

Symptoms Cause
The camcorder does not No battery pack is mounted and no
power on when you set power is supplied to the DC IN
the power switch to ON. connector.
The battery pack is completely
exhausted.
The power supply cuts The battery pack becomes exhausted. Replace the battery pack with a fully charged one
while operating.
The battery pack becomes The ambient temperature is very low. This owes to the battery characteristics and is not a
exhausted very quickly.
The battery pack is inadequately
charged.

Recording/Playback

Symptoms Cause
Recording does not start The power switch is set to OFF.
when you press the REC
The SxS memory card is write-
START/STOP button.
protected.
The SxS memory card is full.
The SxS memory card needs
restoration.
Playback does not start The power switch is set to OFF.
when you press the PLAY
button.
The supplied IR Remote Remote control operation is disabled. Enable remote control operation (page 21).
Commander does not
The battery of the IR Remote
work.
Commander is exhausted.
Audio recording is not The AUDIO LEVEL CH-1/CH-2
possible. knobs are set to the minimum level.
The recorded sound is The audio level is too high.
distorted.
The recorded sound has a The audio level is too low.
high noise level.
Remedy
Mount a battery pack (page 18) or connect to AC
power using the BC-U1 or BC-U2 (page 19).
Replace the battery pack with a fully charged one
(page 18).
(page 18).
defect.
Recharge the battery pack (page 18).
If the battery pack is soon exhausted even after you
charged it fully, it may comes to the end of its life.
Replace it with a new one.
Remedy
Set the power switch to ON.
Release the write-protection, or replace the card with
a non-protected SxS memory card.
Replace the card with one having sufficient space.
Restore the memory card (page 24).
Set the power switch to ON.
Replace the battery with a new one.
Adjust the audio recording levels with the AUDIO
LEVEL CH-1/CH-2 knobs (page 37).
Adjust the audio recording levels with the AUDIO
LEVEL CH-1/CH-2 knobs (page 37), and record
again.
Adjust the audio recording levels with the AUDIO
LEVEL CH-1/CH-2 knobs (page 37), and record
again.
Troubleshooting 155