Usb Flash Drives - Sony PXW-X200 Operating Instructions Manual

It is also necessary to format an SD card for use if
a caution message is displayed when you mount
the SD card.
For an SD card that was formatted with another
system unsupported by this camcorder, the
message "Unsupported File System" is displayed
on the LCD monitor/EVF screen.
Format the SD card as instructed below.
To execute formatting
Using "Format Media" (page 123) of the
OTHERS menu, specify "Media(A)" (slot
A) or "Media(B)" (slot B), then select
"Execute."
An in-progress message and status bar (%) are
displayed, and the ACCESS lamp lights in red.
When formatting is completed, a completion
message is displayed for three seconds.
Note
When formatting, all data in an SD card including
protected images are erased and cannot be restored.
Connection between the camcorder and a PC
To use an SD card in which data have been
recorded with an XDCAM/XDCAM EX-series
product, insert it into the slot of the camcorder
and connect between the PC and this camcorder
using a USB cable.
To use media formatted with this camcorder in
the slots of other devices
Make a backup of the media, then format it using
the other device.

USB Flash Drives

UDF
In UDF or exFAT, you can connect a USB flash
drive to the external device connector (page 12)
to record, save, and load the following data.
• "Loading a Planning Metadata file" (page 54)
• "Storing/Retrieving the Setting Data" (page
53)
The following Sony USB flash drives are
recommended for use with this camcorder.
• USM-M Series
Notes
• Use USB flash drives with a capacity of 4 GB to 32
GB.
26 Using Other Media
• USB flash drives other than those listed above may not
be recognized if connected to the external device
connector.
When using the external device connector
Set "NW&Proxy/USB" (page 114) of the
NETWORK SET menu to "USB A."
Notes
• During this setting, "XAVC-L50 1920×1080/59.94P,
50P" and "XAVC-L35 1920×1080/59.94P, 50P"
cannot be selected for "Format" in "System" (page
121) of the OTHERS menu.
• During this setting, 60fps and 50fps cannot be selected
for "Frame Rate" in "S&Q Motion" when "Format" in
"System" of the OTHERS menu is set to "1920×1080/
29.97P, 23.98P, 25P."
Formatting (Initializing) USB Flash
Drives
USB flash drives must be formatted with the
FAT32 file system.
Note
Before using a drive, format it on this camcorder or a PC.
If a drive formatted on a PC cannot be used, format it on
the camcorder.
1
Connect a USB flash drive to the
external device connector.
If the drive is unformatted or has been
formatted to other specifications, a message
to confirm whether formatting is to be
executed appears on the EVF screen.
2
Using the up/down/left/right buttons or
the jog dial, select "Execute," then press
the SEL/SET button or the jog dial.
The in-progress message and status bar (%)
are displayed, and formatting is started.
When formatting is completed, the message
"Format USB Memory Done" is displayed.
The \MSSONY\PRO\XDCAM\MEMDISC
folder and the \General\Sony\Planning folder
are automatically created in the drive.
If the format operation fails
A format operation may fail because the USB
flash drive is write protected, or because it is not
the type of drive specified for use with this
camcorder.
In this case, an error message appears. Follow the
instructions in the error message and exchange
the drive for one that can be used with this
camcorder.