3
Set “NW&Proxy/USB” (page 114) in
the NETWORK SET menu to
“Network&Proxy.”
Note
It may take time (for about 1 minute) until the
wireless LAN function is activated.
The radio wave intensity indication on the LCD/
EVF screen flashes. Wait until the radio wave
intensity indication stops flashing.
4
Set “Network Mode” in the
NETWORK SET menu (page 114) to
“Station.”
Note
It may take time (for about 1 minute) until the
camcorder is in the station mode.
5
Execute “WPS” in the NETWORK
SET menu.
6
Press the WPS button of the access
point.
For the operation of the WPS button, refer to
the operating instructions of the access point.
When the connection is completed, the radio
wave intensity indication on the LCD/EVF
screen lights at a strength of more than 1.
Note
If the connection fails, perform steps from step 1
again.
7
Connect the device to the access point.
For connecting, refer to the operating
instructions of the device.
8
Start the browser on the device, then
access to “http://<IP address that the
access point assigns to the
camcorder>:8080/index.html.”
For the camcorder’s IP address, check “IP
Address” in the NETWORK SET menu
(page 116).
The screen for inputting “User Name” and
“Password” appears.
For the user name and password of the access
authentication, check “User Name” and
“Password” in the NETWORK SET menu
(page 114).
9
Input the user name and password, then
select “OK.”
Page 62