Connecting To The Internet With A Lan Cable - Sony PXW-X200 Operating Instructions Manual

Connecting to the Internet with a
LAN cable
You can connect the camcorder to the Internet by
attaching the USB-RJ45 adaptor supplied with
the optional network adaptor kit CBK-NA1, via
LAN cables connected to an internet router.
Computer
Router
Attaching the USB-RJ45 adaptor to the
camcorder
1
Open the cover of the external device
connector.
2
Attach the USB-RJ45 adaptor to the
camcorder.
Use the belt supplied with the network
adaptor kit CBK-NA1 to attach the network
cable connected to a USB-RJ45 adaptor to
the camcorder.
Note
Attach/remove the USB-RJ45 adapter while the
camcorder is turned off.
Connecting
1
2
3
Internet
USB-RJ45 adaptor
4
Turn the camcorder on.
Set "NW&Proxy/USB" (page 114) in
the NETWORK SET menu to
"Network&Proxy."
• If USB-RJ45 adaptor is attached properly,
"Network Mode" is automatically set to
"Wired LAN."
Perform connection settings in the
Wired LAN Set menu.
• "DHCP"
Set the DHCP setting.
When you set to "On," the IP address is
assigned to the camcorder automatically.
To assign the IP address to the camcorder
manually, set to "Off."
• "IP Address"
Input the IP address of the camcorder.
This setting is available only when
"DHCP" is set to "Off."
• "Subnet mask"
Input the subnet mask of the camcorder.
This setting is available only when
"DHCP" is set to "Off."
• "Gateway"
Input the default gateway for the access
point.
This setting is available only when
"DHCP" is set to "Off."
• "DNS Auto"
Set to acquire DNS automatically.
When set to "On", the DNS server address
is automatically acquired.
• "1st DNS Server"
Input the primary DNS server for the
access point.
This setting is available when "DNS Auto"
is set to "Off."
• "2nd DNS Server"
Input the secondary DNS server for the
access point.
This setting is available only when "DNS
Auto" is set to "Off."
When you complete the inputs, select
"Execute" in "Set" to confirm settings.
Connecting to the Internet 65